Description: Product Description Please click: Settings → System → Steam Deck Controller ID.If the Controller ID starts with “MEDA”, then this joystick is perfect for you. GuliKit Electromagnetic Joystick Module for Steam Deck This joystick module is used for repair replacement on Steam Deck. Patented joystick design. Super smooth. Longer work life. The stick touch sensing function only works when the wire on stick cap on Steam Deck is welded manually to the GuliKit joystick module. GuliKit 2 Pack Controller 3D Analog Joystick Thumb Sticks Replacement Repair Parts for Steam Deck To avoid the risk of damage, before the replacement work Turn on your Steam Deck and discharge its battery to below 10%. Be careful that its lithium-ion battery can be very dangerous if accidentally punctured. Do not move other parts but only work on the joystick module during the replacement process, and follow the ESD safety procedures during the replacement process. Installation Step 1: First, turn off your Steam Deck ( it's not turning it into sleep mode ), disconnect any cables Remove SD card first if your Steam Deck has SD card before opening the back cover. Use a pry and insert it into the gap between the back cover and the front cover along with the grip Pry up the back cover to release it from the locking points Hold the front case with one hand, and pull the back cover up carefully with another hand and remove it from the device completely Remove the joystick module cable Step 2: Use the tip of a pair of tweezers to lift up the small locking flap on the joystick cable's ZIF connector and take the cable out of the connector. Grip the cable by the blue pull-tab, not by the cable itself. Use a Phillips driver to remove the three 5.2 mm screws, then you can remove the joystick module off your Steam Deck Desoder the cap touch sensing wire Step 3: Use your soldering station and soldering tool to desolder the touch sensing wire off the board of the original joystick module that you just removed. Next, pull up the cap hard out of the joystick. Now you get the joystick cap with the desoldered wire attached. Plug the cap hard onto Gulikit joystick, and use your soldering station and soldering tool to solder the touch sensing wire to the pad on the board edge of Gulikit joystick module. Your joystick will work without cap touch sensing if the wire is not soldered. Put Gulikit joystick module back to the joystick position of your Steam Deck, install the screws back, plug the cable into the ZIF connector and lock it. New joysticks require calibration to work as expected. To calibrate new thumbsticks, follow the calibration guide belowSteam Deck has its joysticks calibrated from factory, and calibration values vary on each of it. Enter joystick calibration interface on Steam Deck calibration is well finished if you see the spot return to center position ( 0,0 ). Then you are good to screw up the shells and use Steam Deck. How calibrate the GuliKit Joystick replacement Do not install back case before joystick calibration. After Gulikit joysticks are installed, turn on Steam Deck, press the tiny switch on the board of joystick module to get joysticks calibrated. Do not touch joysticks during the process. Take the current spot position as the symmetrical point, move the joystick to the symmetrical position of the central point, next press the tiny calibration switch on the board, release the joystick, and calibration is successfully completed when you see joystick returns to center position (0,0)
Price: 25.99 USD
Location: Syosset, New York
End Time: 2023-09-04T10:32:44.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: GuliKit
Type: Joysticks
